Mounting The Phone On A Wall - Radio Shack SYSTEM 612 Owner's Manual

43-461.fm Page 9 Friday, August 13, 1999 8:52 AM
Caution: The supplied AC adapt-
er supplies 12V DC, delivers at
least 300 mA, and has a plug that
properly fits the telephone's jack.
Using an adapter that does not
meet these specifications might
damage the telephone or the
adapter.
5. Insert the tabs on the narrow end
of the supplied stand into the up-
per slots near the center of the
phone, push the wide end of the
stand until it clicks into place, then
place the Speakerphone on the
desk.
6. Plug the modular cords' other
ends into the modular phone line
jack(s) for Lines 1 through 4, then
plug the AC adapter into a stan-
dard AC outlet.
INITIALIZING
briefly appears, then
12:00 AM EXT 11 FRI
pears.

Mounting the Phone on a Wall

You can mount your telephone on a
wall plate, or you can mount it directly
on the wall using two screws (not sup-
plied) with heads that fit into the key-
hole slots on the bottom of the
telephone.
If you are mounting the phone directly
on the wall, drill two holes 3
(100 mm) apart. Thread the two
screws into the wall, letting the heads
extend about
1. Remove the stand from the bot-
tom of the phone by pressing and
holding in both spring tabs, then
gently pulling the wide end of the
stand and lifting it off.
JAN 01
ap-
15
/ inches
16
3 / inch (5 mm).
16
9