Ease brake calipers onto brake
disks.
Install securing screws 2 on left
and right with specified torque.
Brake caliper on slider
tube
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
disks.
Before driving off, check that the
braking effect kicks in without
any delay.
Operate brakes several times
until brake pads contact brake
disk.
The cable of the ABS sen-
sor could chafe through if
it comes into contact with the
brake disk.
Ensure installation of the ABS
sensor cable close to the front
suspension.
Route ABS sensor cable 7 as
shown in picture.
Install screws 1 on left and
right.
Removing rear wheel
Make sure ground is level and
firm and place motorcycle on
its center stand.
8
117
z