Subaru LEGACY 2004 Service Manual page 12

Rotate the left side counterclockwise.
Rotate the left side clockwise.
4) Tighten two new self-locking nuts.
Tightening torque:
⋅
175 N m (17.8 kgf-m, 129 ft-lb)
3. CASTER
• INSPECTION
1) Place the front wheel on turning radius gauge.
Make sure the ground contacting surfaces of front
and rear wheels are set at the same height.
2) Set the ST into the center of wheel, and then set
the wheel alignment gauge.
ST 927380002 ADAPTER
(1)
(2)
(1) Alignment gauge
(2) Turning radius gauge
Wheel Alignment
To increase camber.
FS-00009
To decrease camber.
FS-00010
3) Measure the caster angle in accordance with the
operation manual for wheel alignment gauge.
Sedan
Wagon
OUTBACK
4. STEERING ANGLE
• INSPECTION
1) Place the vehicle on turning radius gauge.
2) While depressing the brake pedal, turn the steer-
ing wheel fully to the left and right. With the steering
wheel held at each fully turned position, measure
ST
both the inner and outer wheel steering angle.
OUTBACK
Except for OUT-
BACK
FS-00007
FS-11
Rotate the right side clockwise.
Rotate the right side counterclockwise.
Model
Model Inner wheel
37.8°±1.5
37.3°±1.5
FRONT SUSPENSION
FS-00010
FS-00009
Caster
6°00'
5°45'
5°05'
Outer wheel
° °
33.5°±1.5
° °
33.0°±1.5