IBM ThinkPad X40 Hardware Maintenance Manual page 64

Symptom or error
0195
Security hardware tamper
detected
0196
Security hardware removed
0197
Invalid remote change
requested.
0199
System Security—IBM Security
password retry count exceeded.
01C8
More than one modem devices
are found. Remove one of
them. Press <Esc> to continue.
01C9
More than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
0200
Failure Fixed Disk—Fixed disk
is not working or not configured
properly.
(continued)
Symptom-to-FRU index
FRU or action, in sequence
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select "Password" -->
"IBM Security Chip" -->
"Clear IBM Security Chip"
to clear this error.
2. Security chip.
3. System board.
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select "Password" -->
"IBM Security Chip" -->
"Clear IBM Security Chip"
to clear this error.
2. Security chip.
3. System board.
The remote configuration for
the security chip has failed.
Confirm the operation and try
again.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
1. Remove either a Mini-PCI
Card. Otherwise, press
Esc to ignore the warning
message.
2. System board.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
1. Reseat the hard-disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard-disk drive.
4. System board.
ThinkPad X40
59