Table of Contents
Advertisement
Adjust the position to ensure the gaps between the body and the four sides of ceiling are even.The
body's lower part should sink into the ceiling for 10~12mm (Refer to chart5).
Locate the air conditioner firmly by wrenching the nuts after having adjusted the body's position well.
B. New built houses and ceilings
a. In the case of new built house, the hook can be embedded in advance (refer to the A.b mentioned
above). But it should be strong enough to bear the indoor unit and will not become loose because
of concrete shrinking.
b. After installing the body, please fasten the installation paper board onto the air conditioner with
bolts (M6X12) to determine in advance the sizes and positions of the hole opening on ceiling.
Please first guarantee the flatness and horizontal of ceiling when installing it.Refer to the A.a
mentioned above for others.
c. Refer to the A.c mentioned above for installation.
d. Remove the installation paper board.
(2) Install The Panel
1) Remove the inlet grid.
a. Slide two grid switches toward the middle at the same time, and then pull them up. (Refer to chart 8)
b. Draw the grid up to an angle of about 45, and remove it. (Refer to chart 9)
onto corresponding hangers of the body.
c. Adjust the four panel hook screws to keep
the panel horizontal, and screw them up to
the ceiling evenly.
d. Regulate the panel in the direction of the
arrow in Chart 11(4) slightly to fit the
panel's center to the center of the ceiling's
opening. Guarantee that hooks of four
corners are fixed well.
2) Remove the installation covers at the four corners.
Wrench off the bolts, loose the rope of the installation covers, and
remove them. (Refer to chart 10)
3) Install the panel
a.
Align the swing motor on the panel to the tubing joints of the body
properly. (Refer to chart 11)
b.
Fix hooks of the panel at swing motor and its opposite sides to the
hooks of corresponding water receiver. Then hang the other two panel hooks
10
Advertisement
Table of Contents
