Table of Contents
Advertisement
Figure 6-2. Fan Tray
screw latch
Install the fan trays after the chassis is installed securely in the equipment rack. Access the fan tray slots
from the rear side of the chassis. To ensure proper temperature and airflow control, all six fan trays must
be installed before you supply power to the system. You will need a #2 Phillips screwdriver to tighten the
screws that secure the fan trays to the chassis. A fan tray can be installed in any fan tray slot.
To install fan trays:
WARNING:
Table 6-1
hazardous voltages. Do not attempt to operate this system without the safety cover provided with each PEM.
Step
Task
Unpack the fan tray.
1
Prior to inserting a fan tray, fully turn its screw latch counter-clockwise (with flathead screwdriver) until the fan
2
tray latching mechanism fully retracts into the fan tray (see
Grip the fan tray handle. Slide the connector end of each fan tray into the slot until it stops and the handle end is
3
flush with the chassis rear.
Secure the fan trays into place by turning the screw latch clockwise.
4
Table 6-1. Fan Tray Safety Labels
Label
28
|
Installing Fan Trays
is an illustration of the fan tray safety labels: Prevent exposure and contact with
Location
Fan tray faceplate
Figure
6-2).
Advertisement
Table of Contents
