Setup Of C-Mor; Setup In Existing Network - C-MOR GP User Manual

C-MOR 6P
1.3

Setup of C-MOR

Make sure that the device is set up on a safe and even surface where it is not exposed to intensive
humidity or extreme variations in temperature. C-MOR must not be exposed to direct sunlight. For
safety reasons C-MOR should be set up where only authorized personnel has access. Your recordings
are only safe if C-MOR is protected from demolition and theft!
Connect C-MOR to the power supply using the power cable and to the network using the
network cable (2 m).
The interface marked with the sticker "ONLY FOR AUTHORIZED PERSONNEL" is not suitable for
network operating but only for maintenance use. Please do not use that connection!
1.4 Setup of Existing Network
Connect LAN1 of C-MOR with your network. C-MOR will be ready for operation as soon as you have
specified an IP address of your network area as described under Administration/Change
of IP Address.
User Manual
LAN 1
Page 6