Menu Map; User Configuration - Varytec Easymove XL 60 Spot User Manual

<ENTER> button to select the menu function currently displayed, or to enable a menu option. To
return to the previous option or menu without changing the value, press the <MENU> button.
No alterative worth that return re-option or menu , press(MENU)button
4.2.

Menu Map

RPON
AU01
AU02
SNOF
SNON
RPOF
RPON
RTON
RTOF
RDOF
DFON
Note ! the factory settings are DMX address A001 and every function is non inverted.
4.3.

User configuration

Setup automatic moving mode(self-motion move)
.Press the MENU until it shows AU01
.Use the UP/DOWN buttons to set to AU01 or AU02 , Press ENTER to confirm.
Sound to light moving mode(sound control)
.Press the Mode button until it shows SNOF .
.Use the UP/DOWN buttons to set to SNON, press ENTER to confirm.
Master/slave mode(auto-running、sound control)
This mode will allow you to link up 32 units together without a controller.
Use standard DMX cables to daisy chain your fixtures together via the DMX
connector on the rear of the units. Proper performance it may be necessary to
use a terminator at the last fixture. Choose a unit to be the Master. Select NAFA/NASL OR NStS (see
below for readout)depending upon which master mode your require. The master
unit must be the first unit in line. Finally ,chain the units together using DMX cable.
To set the pan to inversion
Press the MENU until it shows RPOF.
Use the UP/DOWN buttons until it shows RPON, press ENTER to confirm.
set up the dmx address A001 – A512
fast speed movement
slow automatic movement
Sound to Light OFF
Sound to Light ON
TILT and Pan are non inverted
invert PAN
invert Tilt
invert the display
non invert the display
default settings
6 / 9