Operating; Starting The Device; Main Menu - Varytec Hero Mirror Moving Head User Manual

Operating

7 Operating

7.1 Starting the device

7.2 Main menu

DMX address
Hero Mirror
14
Moving Head
CAUTION!
Risk of injury due to device movements
The device head may perform fast movements (pan, tilt) and reflect very
bright light. This is also the case immediately after switching on the
device, with automatic or remote operation, and while a connected
DMX controller is in off state. Persons who are in the immediate vicinity
of the device may be injured or frightened by this.
Before switching on and during operation, make sure that nobody is in
the immediate vicinity of the device. If any work is to be carried out
within the movement range or in the immediate vicinity of the device,
the device must remain switched off.
Connect the device to the power supply to start operation. After a few seconds, the
fans start to work, the head moves to the home positions for rotation (pan) and incli‐
nation (tilt). The device is now operational.
1.
Press [SET] to activate the main menu.
2.
Use [UP] and [DOWN] to change the respectively displayed value. When the
display shows the desired value, press [SET].
3.
To exit the menu item without making changes, press [ESC].
4.
If you don't press any button for 30 seconds the display turns off. A short press
on [ESC], [SET], [UP] or [DOWN] will then turn it back on.
All previous settings are retained even when you switch the device off and discon‐
nect it from the mains.
Use the 'DMX Address' menu to set the DMX address.
1.
Press [SET] to activate the main menu.
2.
Use [UP] or [DOWN] until the display shows 'DMX Address' and confirm with
[SET].
3.
Use [UP] or [DOWN] to select a value between '001' and '512' to set the desired
DMX address and confirm with [SET].
Make sure that this number matches the configuration of your DMX controller. The
following table shows the respective highest possible DMX address for the various
DMX modes.