JVC HR-S9700EU Instructions Manual page 25

TimeScan
Names of
special-effects
playback
Speed SP -9x -7x -5x -3x
Speed LP — -7x
Speed EP — -7x
Audio output
* Still mode cannot be engaged using the remote control's
**Smooth slow motion delivering an uninterrupted moving image without distortion.
±1/6x and ±1/18x search of EP recordings are not Time Jog.
If the picture jitters vertically, noise appears or the upper or lower part of the picture is distorded at -1/2x, -1/3x, 1/3x, 1/2x or 1.5x
normal speed, use PR + or – to correct the picture.
Noise may appear during TimeScan search, depending on the search speed.
When noise appears or the upper or lower part of the picture is distorted during TimeScan, press
or – button.
The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be distorted.)
To resume normal playback, press
Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback once,
and then try using TimeScan again.
The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with LP/EP
recordings.)
Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP/EP
recordings, or depending on the tape being used.
Picture may appear distorted in comparison to normal playback.
When normal playback resumes from search (including TimeScan), still, slow motion or frame-by-frame playback, the picture may
jitter vertically momentarily depending on the type of TV being used.
During TimeScan there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 1.5x or 2x
normal speed, the audio playback may be faster than normal.
Depending on the type of tape contents, the sound may not be clear during forward slow-motion playback.
Time Jog cannot be activated by pressing
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
Time Jog does not work with NTSC playback.
When playing back an NTSC tape, the speeds differ from those listed above and are not shown on the TV screen.
TimeScan at -1/2x, 1/2x and 1.5x normal speed are not possible with a MESECAM tape.
The operations by JOG dial/SHUTTLE ring do not include TimeScan. Noise will appear on the screen and audio will not be output.
If you do not want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF". (
Reverse
Slow-Motion
Search Play
(Time Jog**)
-1x -1/2x -1/3x
— -3x — -1/2x
— -3x — -1/6x -1/18x
Audio is not
Audio is output.
4
.
9
for longer than 2 seconds.
Slow-Motion
*Still
(Time Jog**)
0 1/3x
— 0 —
0 1/18x 1/6x
Audio is Audio is
output. output. output.
w e
or button. Still mode can be engaged by pressing the
Forward
Play
1/2x 1x 1.5x 2x
1/2x 1x 1.5x 2x
1x — 2x
Audio is output.
p
and adjust tracking with PR +
pg. 71)
25
EN
Search
3x 5x 7x 9x
— 5x — 9x
— 5x — 9x
9
button.