JVC HR-S9500EK Instructions Manual page 31

VCR/TV/SAT
1
NUMBER "1"
4
7
1
STOP
TV PROG+/–
A/B
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL
CODE
2
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
2 3
2
NUMBER
5 6
8 9
0
4
Satellite Receiver Multi-
Brand Remote Control
Your remote control can operate the basic functions of your
satellite receiver set. In addition to JVC satellite receivers, other
manufacturer's satellite receivers can also be controlled.
Before you start . . .
Turn on the satellite receiver using its remote control.
Set the remote control's VCR/TV/SAT switch to SAT.
SET SATELLITE RECEIVER
BRAND CODE
1
Refer to the chart below. While holding down
recorder's remote control, enter your satellite receiver's
brand code using the NUMBER keys, then press STOP.
Check if the satellite receiver's power goes off as it
should. If it does, try other operations (
Once you have set the remote control to operate the
satellite receiver, you don't have to repeat this step
until you replace your remote control's battteries.
Some satellite receiver brands have more than one
code. If the satellite receiver does not function with
one code, try entering another.
OPERATE SATELLITE
RECEIVER
2
Press the corresponding button:
NUMBER keys.
For VIDEOWAY or some brands of satellite receiver, you
must press after having pressed the NUMBER keys.
The NUMBER buttons may not function with some
satellite receivers.
To return the remote to video recorder control, set the
VCR/TV/SAT switch to VCR.
IMPORTANT
Although the provided remote control unit is compatible with
JVC satellite receivers, as well as many other models, it may not
work with your satellite receiver, or in some instances, may
have limited function capability.
SATELLITE RECEIVER BRAND
JVC
AMSTRAD
BT
CANAL +
FINLUX
GRUNDIG
HIRSCHMANN
ITT
JERROLD
KATHREIN
LUXOR
MASPRO
NOKIA
PACE
PANASONIC
PHILIPS
RFT
SALORA
SIEMENS
SKYMASTER
VIDEOWAY
WISI
31
on the
step 2).
, TV PROG +/–,
CODE
72, 73
60, 61, 62, 63
72
81
68
64, 65
64
68
75
70, 71
68
70
68
65, 67
74
66
69
68
64
69
76
64