Important Safety Instructions; Important Safety Information - Hatco FLOWMAX FM2SS-7 Series Installation And Operating Manual

English
Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING
ELECTRIC ShOCK hAzARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Turn power switch OFF, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not allow power cord to hang over edge of counter.
• Turn off unit when filling with water and avoid
splashing.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by hatco, an
Authorized hatco Service Agent, or a person with
similar qualifications.
• Use only Genuine hatco Replacement Parts when
service is required. Failure to use Genuine hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in hatco equipment.
Units are equipped with a high temperature limit safety
switch that will shut off power if water level is below 2 liters
(0.5 gallons) and unit overheats. Allow unit to cool and refill
with water before operating.
Make sure all operators have been instructed on the safe
and proper use of the unit.
This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at
(0512) 6732-5091; fax (0512) 6732-5092.
Form No. FM2SSM_CN-0810

IMPORTANT SAFETy INFORMATION

BURN hAzARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• hot water in unit may cause scalding injury. Allow unit
to cool before draining or cleaning.
• Make sure cover is securely in position before starting
brew cycle. hot water and escaping steam may cause
scalding injury during the brew cycle.
• Do not move or relocate unit when it contains hot
liquids. Turn off unit and allow to cool completely
before moving or cleaning.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch finish of unit, marring its appearance and making
it susceptible to soil accumulation.
Make sure a minimum of 2 liters (0.5 gallons) of water is in
unit before plugging in or operating. Operating unit with
less than 2 liters (0.5 gallons) of water will cause unit to
overheat.
Use only cool water when filling unit.
3
CAUTION
NOTICE