Installing A Scsi Hard Disk Drive - IBM eserver xSeries 306 Option Installation Manual

Installing a SCSI hard disk drive

Complete the following steps to install a SCSI hard disk drive.
Note: If you have only one hard disk drive, install it in the left drive bay.
Hard disk drive
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Press the release tabs on the bezel and pull the bezel away from the server.
4. Slide the drive tray out of the server.
5. Position the drive on the drive tray.
6. Secure the drive using the screws that come with the option.
7. Slide the drive tray back into the server.
8. Connect the signal and power cables to the drive.
9. Reinstall the bezel.
14
xSeries 306 Type 8836: Option Installation Guide
Screws
page 7.
all external cables. Remove the cover (see "Removing the cover" on page 9).
Drive tray
Screws