Headlight Washers - If Equipped; Tilt/Telescoping Steering Column - Jeep Grand Cherokee Owner's Manual

The Rain Sensing system has protection fea-
tures for the wiper blades and arms, and will
not operate under the following conditions:
• Low Ambient Temperature — When the
ignition is first turned ON, the Rain Sensing
system will not operate until the wiper switch
is moved, vehicle speed is greater than
0 mph (0 km/h), or the outside temperature is
greater than 32°F (0°C).
• Transmission in NEUTRAL Position —
When the ignition is ON, and the transmis-
sion is in the NEUTRAL position, the Rain
Sensing system will not operate until the
wiper switch is moved, vehicle speed is
greater than 5 mph (8 km/h), or the shift lever
is moved out of the NEUTRAL position.
HEADLIGHT WASHERS — IF
EQUIPPED
The multifunction lever operates the headlight
washers when the ignition switch is in the ON
position and the headlights are turned on. The
multifunction lever is located on the left side of
the steering column.
To use the headlight washers, push the multi-
function lever inward (toward the steering col-
umn) to the second detent and release it. The
headlight washers will spray a timed high-
pressure spray of washer fluid onto each head-
light lens. In addition, the windshield washers
will spray the windshield and the windshield
wipers will cycle.
NOTE:
The headlight washers will operate on the
first spray of the windshield washer and
then every tenth spray after that.
TILT/TELESCOPING STEERING
COLUMN
This feature allows you to tilt the steering col-
umn upward or downward. It also allows you to
lengthen or shorten the steering column. The
tilt/telescoping control handle is located below
the steering wheel at the end of the steering
column.
Tilt/Telescoping Control Handle
To unlock the steering column, push the control
handle downward (toward the floor). To tilt the
steering column, move the steering wheel up-
ward or downward as desired. To lengthen or
shorten the steering column, pull the steering
wheel outward or push it inward as desired. To
lock the steering column in position, push the
control handle upward until fully engaged.
87