Status And Service Menu - InFocus in5300 series User Manual

Up-Down-Select-Source. Use the navigation buttons on the remote or keypad to
enter the correct 5-button press sequence. When all 5 numbers are entered correctly,
press the Select button on the remote or keypad to select OK. If the message
"Wrong PIN" appears, verify the code and re-enter it. If you mis-enter a number,
you must enter 5 numbers and press the Select button in order to access the "Wrong
PIN" message and re-enter the code.
To enter the PIN at projector startup:
Power up the projector. The "Enter PIN" dialog box appears after the startup screen.
Enter the PIN. Use the navigation buttons on the remote or keypad to enter the
correct button press sequence. See the description above for instructions.
To change the PIN:
Select "Change PIN..." in the Setup menu. Enter the existing PIN. Enter the new
PIN. You can navigate between OK and Cancel by pressing the arrow buttons on
the keypad. Select OK or Cancel by pressing the Select button. Verify the new PIN.
If you lose or forget your custom PIN:
Contact InFocus support at www.infocus.com/support.
Serial Port, Baud Rate: Selects the serial port and baud rate.
Serial Port Echo: Controls whether the serial port echoes characters.
Setup menu

Status and Service menu

Source Info: Displays current source settings (read-only).
Projector Info: Displays current projector settings (read-only).
Reset Lamp Hours: Resets the lamp hours used counter in the Projector Info menu
to zero. Do this only after changing the lamp.
Factory Reset: Restores all settings to their default.
Service Code: Only used by authorized service personnel.
32
Status and Service menu