Cluster-Specific Parameters - Coyote Point Systems Equalizer Installation And Administration Manual

debug_ip
This is the IP address of the debug interface. The default setting restricts this to the local
machine. Do not set this to anything unless instructed to do so by Coyote Point service
personnel.
cycle_time
This is the time, in milliseconds, between successive loops of the Load Balancer
Management Daemon.
flags
Various flags can be set here:
none
enable_outbound_nat—not currently used.
pasv_ftp—enables PASV FTP translation. (See Chapter 4 for more information.)
pedantic_agent—if server agents are enables and the agent does not respond, the
server will be marked DOWN.

Cluster-Specific Parameters

The following parameters can only appear within a cluster body, and the scope of the
parameter is the virtual cluster, unless overridden by a match group parameter setting.
protocol
The protocol of the virtual cluster must always be specified, and it should be specified
first, as the protocol selection makes other parameters and flags available.
Currently supported protocols are:
udp_l4
tcp_l4
http
https
port
The TCP or UDP port number of the virtual cluster. Depending on the protocol, this can
have a default value supplied, such as port 443 for HTTPS.
ip
The IP address of the virtual cluster. This is the external IP address which clients will use
to connect to the cluster.
Equalizer Installation and Administration Guide
Cluster-Specific Parameters
113