Advertisement
Document No. 129-497
Installation Instructions
May 18, 2011
Dimensions
3.78 (96)
Figure 8. RDF Controller Dimensions in Inches (mm).
Operating Instructions
Normal Operation
The +/- buttons allow you to increase or
decrease the current room temperature
setpoint in steps of 1°F (0.5°C).
To do this, proceed as follows:
• Press and hold
The setpoint display starts flashing.
• Press the buttons again to change the
room temperature setpoint in the range
41°F to 95°F (5°C to 35°C). The new
temperature setpoint will automatically
be stored 10 seconds after the last
adjustment is made. The display will
then stop flashing.
Page 4 of 7
1.38
(35)
or
once.
1.10
(28)
1.77
( 5)
.21
(107)
0.16 ( )
1.18
(30)
Figure 9. Base Plate Dimensions.
Changing from Heating to Cooling Mode
/
Automatic changeover
Display shows that heating valve is open
Display shows that cooling valve is open
Selecting the Three Fan Speeds with the Operating
Mode Selector
High
Medium
Low
Changing from Heating or Cooling Mode to Standby
With all RDF types, the operating mode
selector is used to manually change from
Heating or Cooling mode to Standby
/
In Standby
adjusted lower heating setpoint P03 or higher
cooling setpoint P04.
Changing from Normal Operation to Economy Mode
Changeover from normal operation to Economy
/
mode takes place automatically via an external
contact (window switch/remote operation switch,
etc.).
Display shows normal operation.
Display shows Economy mode.
1.10
0. 6
(28)
(11,8)
1.10
(28)
1.10
(28)
0.28
(7)
0.98
(25)
3.5
(90)
, all controller types maintain the
Siemens Industry, Inc.
.
Advertisement
