Installation - Mounting The Water Heating Unit - Heatrae Sadia Aquatap Installation & User's Instructions

INSTALLATION – MOUNTING THE WATER HEATING UNIT
4.0
4.1 The AQUATAP water heating unit is free standing and must be positioned on a level
surface. If being mounted in a cupboard, shelf unit or false base, ensure that the
supporting surface can carry the full weight of the unit (see TECHNICAL
SPECIFICATIONS Section 2.0, page 4)
4.2 Refer to FIG. 1, page 4 for details of the dimensions of the AQUATAP water heating unit
and the relative positions of the water and electrical connections.
4.3 The AQUATAP heater unit must be located beneath the dispensing tap.
It must be possible to connect the flexible hoses and electrical connection cable from the
dispensing tap to the OUTLET and VENT connections on the AQUATAP unit. The pipes
must not be lengthened. The dispenser tap can be positioned so it discharges into a sink
or mounted on its own purposed designed drip tray (available as an accessory, Product
Code 95970138).
4.4 Sufficient room should be left around the unit to allow access for maintenance and
servicing (see FIG. 1, page 4). Two of the case fixing screws are located on the top
rear edge of the unit; it must be ensured that these can be accessed in order to facilitate
removal of the front cover for maintenance and servicing.
4.5 The AQUATAP water heating unit is supplied with a fitted 1.5 metre electrical supply
cable. It is recommended that this is connected to a fused double pole isolating switch
within this distance. If the cable needs to be lengthened this must be done by a qualified
electrician. Refer to Section 9.0, page 14 - INSTALLATION – ELECTRICAL
REQUIREMENTS for full details of the electrical installation.
8