Heatrae Sadia Aquatap Installation & User's Instructions page 13

8.5 Plug the dispensing tap cable connector into the control box plug marked
"DISPENSER". Plug the lead from the control box into the Aquatap heater.
8.6 Wire up the control box as described in 9.6, page 14.
8.7 If a chiller unit is fitted to the dispenser, site the chiller near to both the Aquatap heater
and control box.
8.8 Connect the water supply to the chiller as per the manufacturers instructions. The chilled
water supply via a 6mm pipe from the chiller should be connected to the "inlet" side of
the control box, a 6mm to 8mm John Guest fitting is supplied for ease of use.
8.9 The dispenser tap chilled/ambient hose should be connected to the "outlet" pipe of the
control box and secured in place with the pipe clamps supplied.
8.10 Plug the dispensing cable connector into the control box plug marked "dispenser". Plug
the lead from the control box into the Aquatap heater.
8.11 Wire up the control box as described in 9.6, page 14.
FIGURE 8 : TAP MOUNTING (BOIL & CHILL)
(NOTE: DRIP TRAY/SINK NOT SHOWN FOR CLARITY)
CLAMP
WHITE HOSE
HOT TAP
OUTLET
HOSE
TAP
VENT
HOSE
CLAMP
1.5mm 3 CORE HOFR
SHEATHED CABLE
DISPENSER CABLE
CONNECTOR
CONTROL
BOX
CONNECTOR
1.5mm 3 CORE HOFR
SHEATHED CABLE
FLEXIBLE
HOSE
ISOLATING
VALVE
FUSED SPUR
1.5mm 3 CORE
SHEATHED CABLE
CHILLED WATER
SUPPLY
MAINS
WATER
SUPPLY
CHILLER
UNIT
13