Checking, Canceling Or Changing Programme Settings; Automatic Satellite Programme Recording - JVC HR-J690EU Instructions Manual

Checking, canceling or changing programme
settings
A
Disengage timer recording standby mode
Press #, then press 1.
When "AUTO TIMER" is set to "ON" (
B
Access Program Check screen
Press ".
C
Access Program screen
Press " again. Each time you press ",
the next programme's screen appears.
D
Cancel or change programme setting
To cancel a programme, press &.
To change a programme, press the
appropriate button: START+/–, STOP+/–,
DATE+/–, DAILY (number key "8"), WEEKLY (number key "9"),
PR+/–, VPS/PDC (number key "7") and/or SP/LP (p).
To change "TV PROG" to "SAT" for the channel position, press
the number key "0".
E
Return to normal screen
Press " repeatedly until no Program screen is shown.
F
Re-engage timer recording standby mode
Press #. The recorder turns off automatically and "#" is displayed
on the display panel.
When "AUTO TIMER" is set to "ON" (
recording standby mode automatically resumes when you turn
off the recorder.
12), press only 1.
12), the timer
— 10 —

Automatic Satellite Programme Recording

You can automatically record a satellite programme which is
timer-programmed on your satellite receiver.
A
Connect a satellite receiver to the L-2 IN/DECODER connector
on the rear panel.
B
Set timer programme on satellite receiver referring to its
instruction manual.
C
Load a cassette with the record safety tab intact.
D
Set "L-2 SELECT" to "A/V" or "SAT". (
E
To set the tape speed, press SP/LP (p). The current setting for
the tape speed appears on the display panel or the screen for
about 5 seconds. Press SP/LP (p) again to change the setting
while tape speed is displayed.
F
Press SAT# for more than 2 seconds. The recorder turns off
automatically and enter the Automatic Satellite Programme
Recording mode (the SAT# indicator lights up). When signals
come into the recorder from the satellite receiver, the recorder
starts recording (the SAT# indicator blinks). The recorder stops
recording and turns off when signals stop coming in.
NOTES:
Be sure not to turn on the satellite receiver before the
programme starts broadcasting; otherwise, the recorder starts
recording when the satellite receiver is turned on.
To disengage the Automatic Satellite Programme Recording
mode, press SAT# (the SAT# indicator goes off).
Depending on the type of satellite receiver, Automatic Satellite
Programme Recording may not be compatible.
B.E.S.T. does not work in the Automatic Satellite Programme
Recording mode.
Power Save mode does not work in the Automatic Satellite
Programme Recording mode.
Just Clock does not work in the Automatic Satellite Programme
Recording mode.
13)