Table of Contents
Advertisement
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG
control or INDEX ™ or £ on the recorder. "™
1" or "£ 1" is displayed on screen and search begins
in the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or
or INDEX ™ or £ repeatedly until the
correct index number is displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG or INDEX ™ twice.
To locate the beginning of D from the current
position, press PUSH JOG
A
–2
When the specified index code is located, playback
begins automatically.
Instant ReView
Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it's found,
playback begins automatically.
The front display panel tells you how many programmes
have been recorded. If you have, for example, 3
programmes, "REVIEW" and "3" appear and blink. To
watch the first of the 3 programmes, press REVIEW three
times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTE:
Instant ReView is not possible while the recorder is in the Timer
mode.
or
(™ or £) on the remote
or INDEX £ once.
Current position
B
C
D
E
F
–1
1
2
3
Index number
Repeat Playback
Your video recorder can automatically play back the whole tape
£ 2
20 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ($) on the display panel blinks
slowly.
The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
Information On Colour
System
You can also record SECAM signals, or play back a MESECAM
tape on this recorder. When a MESECAM tape is played back,
"MESECAM" appears on the screen for about 5 seconds.
MESECAM is the designation for tapes with SECAM signals that
have been recorded on a MESECAM-compatible PAL video
recorder.
Tape Position Indicator
The tape position indicator
appears on screen when, from
the Stop mode, you press FF,
REW or perform an Index
Search. The position of "5" in
relation to "0" (beginning) or
"+" (end) shows you where you
are on the tape.
"O.S.D." (
set to "ON", or the indicator
will not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
0
pg. 20) must be
Beginning
15
EN
3
+
+
+
1:23:45
REMAIN 2:35
End
Hide quick links:
Advertisement
Table of Contents
