Draytek Vigor2920 Series User Manual page 136

DHCPv6 Server
Configuration
DNS Server IPv6 Address
Static IPv6 Address
configuration
Current IPv6 Address
Table
D e t a i l s
D e t a i l s
Details Page for LAN2 to LAN4 will be available only when VLAN settings for LAN2 to
LAN4 are configured and activated.
Available settings are explained as follows:
Item
Network Configuration
DHCP Server
Configuration
Vigor2920 Series User's Guide
list.
Enable Server –Click it to enable DHCPv6 server.
DHCPv6 Server could assign IPv6 address to PC according
to the Start/End IPv6 address configuration.
Disable Server –Click it to disable DHCPv6 server.
Start IPv6 Address / End IPv6 Address –Type the start
and end address for IPv6 server.
Primary DNS Sever – Type the IPv6 address for Primary
DNS server.
Secondary DNS Server –Type another IPv6 address for
DNS server if required.
IPv6 Address –Type static IPv6 address for LAN.
Prefix Length – Type the fixed value for prefix length.
Add – Click it to add a new entry.
Delete – Click it to remove an existed entry.
Display current used IPv6 addresses.
P a g e f o r L A N 2 / L A
P a g e f o r L A N 2 / L A
Description
Click Enable to enable such configuration.
Click Disable to disable such configuration.
For NAT Usage - Click this radio button to invoke NAT
function.
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatch related IP settings to any local user
N 3 / L A N 4
N 3 / L A N 4
128