Table of Contents
Advertisement
8.2.2
Set the handset priority
When you have more than one handset registered to the base station, you can set which handset to ring first
before the others.
In Idle:
1. Repeat step 1 in section 8.2.1.
2. Press <OK> and <UP/DOWN> to select Handset Priority.
3. Press <OK> and <UP/DOWN> to choose Select Handset.
4. Press <OK> and <LEFT/RIGHT> to select which handset to get the priority to ring first.
Note: If All Handsets is chosen, all the registered handsets will ring at the same time and press <OK> to confirm.
5. Press <OK> and <LEFT/RIGHT> to select the number of ring delay (2 Rings / 4 Rings / 6 Rings / 8 Rings).
6. Press <OK> to confirm.
8.2.3
Set the dial mode
In Idle:
1. Repeat step 1 in section 8.2.1.
2. Press <OK> and <UP/DOWN> to select Dial Mode.
3. Press <OK> and <LEFT/RIGHT> to select Tone or Pulse.
4. Press <OK> to confirm.
8.2.4
Set the flash time
In Idle:
1. Repeat step 1 in section 8.2.1.
2. Press <OK> and <UP/DOWN> to select Flash Time.
3. Press <OK> and <UP/DOWN> to select the desired flash time.
Note:
Flash time options are country dependent.
4. Press <OK> to confirm.
8.2.5
Set date and time
In Idle:
1. Press <Menu> and <4-way key> to select Base Settings.
2. Press <OK> and <UP/DOWN> to select Date/Time.
3. Press <OK> and <LEFT/RIGHT> to select 12 hour or 24 hour format.
4. Press <DOWN> and <LEFT/RIGHT> to select dd/mm or mm/dd date format.
5. Press <DOWN> to enter the time. During time input, press <#> to toggle between AM or PM if 12 hour time
format is selected.
6. Press <DOWN> to enter the date.
7. Press <OK> to confirm.
8.2.6
Change the system PIN
In Idle:
1. Repeat step 1 in section 8.2.1.
2. Press <OK> and <UP/DOWN> to select System PIN.
3. Press <OK> to enter the old 4-digit system PIN.
4. Press <OK> to enter the new 4-digit system PIN.
5. Press <OK> to enter the new 4-digit system PIN.
6. Press <OK> to reconfirm and save the new 4-digit PIN.
Note: If the PIN is incorrect, "INCORRECT PIN" will display with an error tone in the screen.
8.2.7
Set an exchange code
You can set an exchange code for your handset such that a pause will be inserted after the first digit if it matches
with the exchange code. This feature is especially useful for PBX systems.
In Idle:
1. Repeat step 1 in section 8.2.1.
2. Press <OK> and <UP/DOWN> to select Exchange Code.
3. Press <OK> to enter the exchange code.
4. Press <OK> to confirm.
Note:
Only one digit is allowed to enter for the exchange code.
21
Page
Advertisement
Table of Contents
