Table of Contents
Advertisement
System PIN
Exchange Code
10
TROUBLESHOOTING
If you have difficulty with your phone, please try the suggestions listed below.
Problem
No dialing tone when pressing <TALK
ON> key
When connect to a PBX, no and/or
wrong connection after dialing.
"Searching" is displayed.
The call does not work.
No display.
Please contact the technical support of the network provider for further information.
This telephone is not equipped with a grounding function! Therefore some of the functions may be limited when
used in PBX systems.
CONFORMITY
This unit conforms to the following rules and regulations:
1995/5/EC Radio frequency and telecommunication equipment and the mutual acceptance of conformity.
The CE mark proves the above.
0000
Empty
Cause
a.
The connection cord of the base
station is not plugged in.
b.
The adapter cord is not plugged in
correctly in the base station.
c.
The line is busy, as another
handset is used.
d.
Wrong connection cord (no Euro
AS)
Dialing prefix is needed.
Base station out of range.
Base station not connected to mains.
Service not activated or wrong
operator or wrong setting
Empty battery
Solutions
a.
Check the connections. Unplug
and plug back in the mains.
Check that the telephone line cord
has been plugged into the base
station and the phone socket.
b.
Check the base station plug and
the 220V plug (remove and plug-
in).
c.
Wait until the line is unoccupied.
d.
Use the original connection cord.
Insert the dialing prefix
Reduce the range.
Connect base station to mains.
Check your Subscription with network
or change the dial mode.
Recharge battery
23
Page
Advertisement
Table of Contents
