How To Install - Britax Maxi AHR Easy Adjust Instructions For Installation And Use Manual

HOW TO INSTALL

INSTALLING INTO VEHICLE
(FORWARD FACING) (UPRIGHT OR RECLINED)
A. Determine whether an upright or reclined installation
is preferred as shown right.
B. To move the Recline Foot from upright to reclined
mode or vice versa. Pull the Foot outwards to unlock
it, then rotate the foot. Push to lock in place. See
diagrams below.
Pull out
NOTE: Some car seats have more rearward slope than others.
Use a rolled up towel or padding under the seat for contoured
vehicle seats to prevent excessive recline.
If the car seat belt does not remain firm in everyday
use, then contact the retailer, or Safe-n-Sound customer
service for a gated 3-bar slide (order No. 0215).
18 Instructions for Installation & Use - Series No. 8100/A/2010
Upright Reclined
Push in
to lock
Rotate
Rolled up
towel or
padding
C. Position restraint centrally to the chosen position in forward facing mode and align restraint centrally
to the chosen seating position. Some vehicle seat fabrics (particularly velours) may be damaged by
a child restraint used continuously. We recommend the use of the Safe-n-Sound™ Messy Mat or
other protection to keep the vehicle seat in good condition.
Pull the centre panel flap down and gently lift headrest
trim end.
Fully lengthen seat belt and feed the seat belt through
the closest seatbelt path slot and pass across the
seating surface through the opposite slot. Follow the
yellow belt path label - FORWARD-FACING BELT PATH
Yellow Belt Path label
FORWARD-FACING
BELT PATH
Seat belt feeds
through slot in
seat between
trim and seat
Near seat
back.
belt slot
Instructions for Installation & Use - Series No. 8100/A/2010
HOW TO INSTALL
Headrest trim end
Feed through
seatbelt path.
Car's Seatbelt
Centre
panel flap
Engage
into Seat
belt buckle
Far seat
belt slot
19