Table of Contents
Advertisement
SAFETY
Operation of Chair
1. Always ensure that the power is switched off when getting in or out of the power
wheelchair. This will eliminate the possibility of accidentally activating the
joystick and causing injury to yourself or others.
2.Always check that the drive wheels are engaged (drive mode) before driving.
3.Set the speed control knob according to your driving ability and the environment in
which you are going to operate. We recommend that you keep your speed at the
slowest position (fully press the deceleration button) until you are familiar with the
driving characteristics of the vehicle. We also recommend that you use the slowest
speed when using your power wheelchair indoors.
4.Always reduce your speed when making sharp turns.
5.Do not switch off the power when the wheelchair is still moving forward. This will
bring the chair to an extremely abrupt stop.
6.Avoid jerky stop/start motions as it will result in excessive current draw from the
batteries, increased tire wear and the rapid wearing of the gearboxes and motors.
7.To brake in an emergency, simply release the joystick.
Ramps and Curbs
8. When driving up or down ramps, be sure to check that the angle of the slope is
less than 10 degrees (slopes about 1/6). Also check that ramp surface is roughened
to prevent slipping. Never drive across a slope or turn sharply on a slope.
9. When driving up curbs, always check the height of the curb to ensure that it does
not exceed 1-1/2"(40mm) height.
Transfers, Reaching and Bending
10. Transferring on and off the unit requires a good sense of balance. To eliminate the
possibility of injury, we recommend performing the following tasks before
attempting a transfer:
→ Position chair so that the distance between your power chair and the object to
which you are transferring is close enough for a safe transfer.
→ Turn the power off
→ Ensure that your power chair not in freewheel mode.
→ Flip up or remove armrests
→ Flip up footplate or remove footrests
→ Turn both caster wheels towards the transfer direction to improve power chair
stability during transfer.
INSTRUCTION
Advertisement
Table of Contents
