JVC HR-J270 Instructions Manual page 14

14
EN
Setting satellite receiver's brand and
channel
After installation, set the satellite receiver's brand and
channel correctly; otherwise, the Satellite Controller
cannot work correctly.
Turn on the TV and select the video channel (or AV
mode).
A
Turn on the satellite receiver.
Turn on the satellite receiver's power.
B
Access the Main Menu screen on the
recorder.
Press MENU.
SAT CONTROL SET (cont.)
C
Access the Initial Set screen.
rt
Press to move the highlight bar (pointer) to "INITIAL
e
SET", then press OK or
D
Access the Sat Control Set screen.
rt
Press to move the
highlight bar (pointer) to
"SAT CONTROL SET", then
e
press OK or .
E
Enter the satellite receiver's brand.
Press the appropriate NUMBER
keys to enter the brand code
from the list on page 15, then
press OK.
If the brand code you entered is
invalid, the code field will be
reset. Enter the correct brand
code again.
If the recorder is in playback or
recording, you cannot set the
brand code.
F
Select the satellite receiver's channel.
Press the appropriate NUMBER
keys to enter the channel
position on the satellite
receiver, then press OK.
You can select the channel
position between 1 to 999.
After pressing OK, the recorder
enters the Test mode.
.