Table of Contents
Advertisement
30
EN
Edit To
Another Video
Recorder
TV Receiver
VIDEO
CHANNEL
RF Cable (provided)
VCR
1
NUMBER "1"
4
7
1
PLAY
Source player
Your recorder
AV Cable
(not provided)
Another recorder
Recording deck
NUMBER "2"
2
3
2
5
6
8
9
0
4
STOP
You can use your video recorder as the source player and
another video recorder as the recording deck.
MAKE CONNECTIONS
1
Connect the player's AUDIO/VIDEO OUT connectors
to the recorder's AUDIO/VIDEO IN connectors.
SET RECORDING DECK'S
INPUT MODE
2
Set the recording deck's external input mode.
START SOURCE PLAYER
3
Press PLAY on the source player.
START RECORDING DECK
4
Engage its Record mode.
NOTES:
All necessary cables can be obtained from your dealer.
If you do not want to record the superimposed indication on
the editied tape, be sure to set "O.S.D." to "OFF" before you
start editing (
pg. 10).
Remote A/B Code
Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to
B code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
1 Unplug the mains power cord from the mains outlet.
2 While holding down VCR on the remote control, press the
NUMBER key "2" and then press STOP.
3 Plug the mains power cord back into the mains outlet.
4 Press
on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat
the same procedure as shown above except pressing
NUMBER key "1" instead of "2" in step 2.
EDITING
Advertisement
Table of Contents
