Next Function Memory; Ntsc Playback - JVC HR-J246EK Instructions Manual

1 2
4 5
7 8
/
0
2
3
1
REW
¶ 7
4
1
3
C.MEMORY
3
6
9
4
¡
8
¢

Next Function Memory

You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press
NOTE:
If you want the power to be turned off automatically when the
counter reads "0:00:00" (instead of at the beginning of the
tape), press C.MEMORY so that the "M" mark appears before
pressing REW.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LOAD A CASSETTE
1
Insert a cassette recorded in NTSC.
START PLAYBACK
2
Press PLAY.
"NTSC" appears on the screen for about 5 seconds.
Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
The counter and tape remaining time readings will be
incorrect.
During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
17
within 2 seconds.