JVC HR-J246EK Instructions Manual page 23

6
1 2
4 5
NUMBER
8
7
/
DAILY
0
4
2
1
¶
1 4
MENU
3
5
OK
Satellite Receiver Users
To timer-record a satellite broadcast using Video Plus+,
perform steps 1 – 6 and, before the selected programme
begins, select the appropriate channel on the satellite
receiver. Then set the receiver's timer. If your satellite
receiver doesn't have a timer, leave the unit's power
switched on.
¢ ¢
q
¡ 1
4
3
6
9
WEEKLY
4 TIMER
3 ¡
7 8
¢
SET TAPE SPEED
4
Press SP/LP (
RETURN TO NORMAL SCREEN
5
Press OK.
Repeat steps 1 – 5 for each additional programme.
ENGAGE RECORDER'S TIMER MODE
6
Press TIMER. The recorder turns off automatically.
NOTE:
To Delay The Stop Time . . .
. . . press ADD TIME after pressing OK in step 3. Each time you
press, the Stop time is delayed by 5 minutes (meaning that 5
minutes of recording time is added). You can easily compensate
for anticipated programme schedule delays this way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY" appears
on the screen. Pressing the button again makes the correspond-
6
ing indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen and "FULL" appears
on the front display panel. To record the extra programme, you
must first cancel any unnecessary programmes (
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on
the previous page if the Guide Program number for the
PlusCode number you entered has not been set.
If the recorder is in the stop or rewind or fast-forward
mode, the following screen will appear with "– –" under
"TV PROG" blinking.
Press the NUMBER keys or PUSH JOG %fi to input the
preset position number you recorder receives that
station on, then press OK.
GUIDE PROG SET
GUIDE PROG
2
[ 5 ∞] =
[MENU] : EXIT
Press MENU, then try again from step 1.
If the recorder is in a mode other than the above mentioned
modes, press MENU first and input the correct Guide
Program number for that PlusCode number (
"Video Plus+ Setup"), then try again from step 1.
) to set the tape speed.
(Ex.) To timer-record a BBC2
programme with Video Plus+
TV PROG
* If your recorder receives
– –
BBC2 on the preset position
2, press OK after entering
"2".
23
pg. 26).
pg. 10,