Table of Contents
Advertisement
8. Troubleshooting
8.1 I forgot Login ID and Password / I forgot IP address after changing IP address
Use your mobile hot-spot after restoring the configuration into factory-default value.
How to restore the configuration?
•
Press "reset" button for more than 2 seconds and release in normal status.
•
User can see Power Button LED is blinking.
•
After about 15 seconds, mobile hot-spot is automatically turned off.
•
When re-powered on, you can see the configuration is changed to the factory-default value on Web-UI.
Caution: Please make sure mobile hot-spot has enough battery level when factory resetting is performed.
8.2 I cannot connect to the Internet
User should check the displayed icons and messages.
If
Received Signal Strength Indicator
Check whether Wi-Fi icon (
8.2.1 Check Wi-Fi
( )
Check if the Wi-Fi icon
If the Wi-Fi icon is on, connect to the mobile hot-spot by correct SSID. SSID value is different for each mobile
hot-spot to avoid interference. So, each mobile hot-spot has a unique SSID such as "Net1 M-90 1234".
If Wi-Fi is connected, ping to mobile hot-spot's LAN IP address (default: 192.168.0.1).
If ping is not OK, check if SSID is correct, and if Wi-Fi security is configured.
If ping is OK, refer to below Section 8.2.2.
8.2.2 Check CDMA
Check whether the Received Signal Strength Indicator icon
If Received Signal Strength Indicator icon is not displayed, check if the retractable antennas are fully pulled
out or check the status of PPP.
If WWAN (data call) connection status icon ( ) is displayed, PPP connection is established. If not, please
check other configurations on the Web-UI or network configuration of your client device.
icon (
) is not displayed, please refer to below Section 8.2.1.
) is displayed.
is displayed.
(
)
is displayed.
21
Advertisement
Table of Contents
