Panel Leds - Epson TM-T90 Specification

Confidential

3.4 Panel LEDs

1) Power (POWER) LED: Green
On: Power is stable.
Off: Power is not stable.
Flashing: During execution of each operation.
<Flashing pattern>
2) Paper roll end (PAPER OUT) LED: Red
On: The roll paper near end or real end is detected.
Off: Paper is loaded (normal condition).
Flashing: • Self-test waiting state for test print.
• Macro execution standby state when the macro execution command is used.
State
Waiting for self-test printing
to be continued or macro
execution ready state.
NOTE: A macro can be executed r times (r specifies the number of times to execute the macro)
within the specified definition range. The macro can be executed continuously or can be
executed by pressing the button. If the macro is executed by pressing the FEED button, the
PAPER OUT LED flashes to indicate the macro execution ready state. (See Section 6,
Commands.)
EPSON
Power on (during each execution): Flashing
Approximately 320 ms
Power off termination (after executing DLE DC4 2): Flashing
Table 3.4.1 Standby State Indication
PAPER LED flashing pattern
PAPER OUT
TITLE
TM-T90
Specification
(STANDARD)
Recovery conditions
Pressing the FEED button
causes self-test printing to be
Approximately 320 ms
continued or executes the
macro.
SHEET
REVISION
F
NO.
NEXT SHEET
61 60