Dvd Self Diagnostic Function-Error Code - Panasonic SA-VK960GC Service Manual

SA-VK960GC / SA-VK960GCS / SA-VK960GCT / SA-VK960GS
9.4.

DVD Self Diagnostic Function-Error Code

9.4.1. DVD Module Error Code Table
Error
Diagnosis Contents
Code
U702 HDMI/DVI I2C
communication error when connecting it with HDMI/
U703 HDMI/DVI attestation When attestation (HDCP) with the TV
error
U704 HDMI/DVI SRM
Riborcerar
U705 HDMI/DVI SRM disk It is generated at the time of it is time
falsification check
error
F740 HDMI device key
F893 FLASH ROM IC data Firmware error, DV5 LSI IC (IC8651)
falsification error
F894 EEPROM IC
abnormality error
F895 Language area
abnormal
F896 No existence model
F897 Initialization
error
F898 Disagreement of
hardware and
software
F899 The communication
specification
disagreement
between
micro-processor
Description of error
The communication error of I2C
DVI. For instance, when EDID
information to which information on the
TV set side has been described
cannot be read, it is generated.
side fails when connecting it with
HDMI/DVI, it is generated.
It is generated at the equipment to
which the TV set is Riborced when
connecting it with HDMI/DVI.
when illegal the SRM data of the
reproducing disk (verify error), when
connecting it with HDMI/DVI.
I2C error when writing HDMI Key
device into transmitter.
error.
When failing in the access to
EEPROM IC located in the DVD
Module P.C.B. (IC8611)
Firmware version agreement check for
factory preset setting failure
prevention.
Firmware version agreement check for
factory preset setting failure
prevention.
Incomplete initialization after writing of
new firmware (Factory preset setting
failure prevention)
Unsuitable combination of AV Decoder,
SDRAM & FLASH ROM IC (firmware).
Unsuitable combination of number of
system com and panel com used.
(Frimware)
Automatic FL Display
38
Remarks
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.