Updating Aja Oem-2K Pci-X Firmware - HP xw8400 Workstation Hardware Setup Manual

VTR-Emulation Control Cable:
3rd-Party Device Master Controlling Linux/AJA Emulator
3rd-Party Device Master
MALE DB9

Updating AJA OEM-2K PCI-X Firmware

System configuration is done prior to delivery by an authorized technician, and some of the
procedures in this guide may not be necessary. The update procedures are provided here for
informational purposes.
Your workstation's AJA OEM-2K board must contain the certified PCI-X firmware required by
the version of your Effects or Editing application. If the PCI-X firmware version on your AJA
OEM-2K board does not correspond to the table below, you must update to the certified
version.
Autodesk Effect or Editing Product Version Certified PCI-X Firmware Version
2007 SP1
2007 SP2
1
6
2
7
3
8
4
9
5
2 - RX -
PAIR 1
7 - RX +
8 - TX -
PAIR2
3 - TX+
4 - GND (SHIELD)

Updating AJA OEM-2K PCI-X Firmware

Linux/AJA Emulator
OEM-2K: MALE DB9
OEM-LH: FEMALE DB9
8 - TX -
WHT
3 - TX +
BLK
2 - RX -
RED
7 - RX+
BLK
4 - GND (SHIELD)
GND
0x39
0x50
1
6
2
7
3
8
4
9
5
27