Rear Panel - JVC BR-DV6000 Instructions Manual

NAMES AND FUNCTIONS
OF PARTS
Y/C
2
3
4
SIGNAL
GND
1
[VIDEO LINE IN] terminal (BNC)
This is the input terminal for composite video
signals.
• To input video via this terminal, set the IN-
PUT SELECT switch located on the front
panel to "LINE".
2
[VIDEO Y/C IN] terminal (4-PIN)
This is the input terminal for YC separate video
signals.
• To input video via this terminal, the following
settings are required.
Set VIDEO INPUT SEL in the VIDEO Menu
screen to "Y/C".
Set the INPUT SELECT switch located on
the front panel to "Y/C (CPN)".
• When wide-screen ID signals are input, the
wide-screen ID signal is recorded.
3
[VIDEO LINE OUT] terminal (BNC)
This is the output terminal for composite video
signals.
4
[VIDEO Y/C OUT] terminal (4-PIN)
This is the output terminal for Y/C separate video
signals.
• When tapes that have recorded wide-screen
signals are played back, the wide-screen ID
signal is output.
16
1 6
COMPONENT
VIDEO
LINE
IN
R-Y
Y
OUT
MONITOR
IN
OUT
SYNC IN TIME CODE
IN
DV
SERIAL
IN/OUT
DC12V REMOTE
5 8 0
7 ! @
REMOTE2
IN
B-Y
AUDIO
OUT
CH 1/3 CH 2/4
IN
OUT
OUT
OUT
OFF
REC PLAY
MONITOR
TIMER
OUT
9 # %
5
[VIDEO MONITOR OUT] terminal
(BNC)
This terminal is for connecting to a monitor-TV.
• It outputs composite video signals.
• It displays the Menu setting screen, Date/
Time setting screen and warning information.
• If DISPLAY in the DISPLAY Menu screen is
set to "ON" or "AUTO", information will be dis-
played on-screen, e.g., the operation mode,
date/time and counter. (
6 [COMPONENT IN] terminal
(BNC 3)
This is the input terminal for component video
signals (Y/R-Y/B-Y). The signal level is high (ß
cam spec).
• To input video of this terminal, the following
settings are required.
Set VIDEO INPUT SEL in the VIDEO Menu
screen to COMPONENT.
Set the INPUT SELECT switch located on
the front panel to "Y/C (CPN)".
7
[COMPONENT OUT] terminal
(BNC 3)
This is the output terminal for component video
signals (Y/R-Y/B-Y). The signal level is high (ß
cam spec).
Memo
Whether or not to enable SET UP for analog
signals (composite, YC separate and compo-
nent signals) can be selected with SET UP in
the VIDEO Menu screen (for NTSC only).
– Rear panel –
REMOTE1
☞
Page 20)
$