Installing Sa-K46U Rs-232C Interface Board - JVC BR-DV6000 Instructions Manual

OTHERS
The RS-422A REMOTE 1 terminal of BR-DV6000 can be replaced with SA-K46U RS-232C inter-
face board. Use the plate for the RS-422A REMOTE 1 terminal for installing SA-K46U RS-232C
interface board.
The replacement procedure is described below. However, to prevent electrical shock or injury, the
work should be performed only by a qualified personnel or a JVC authorized service agent.
A
AUDIO
CH 1/3 CH 2/4
IN
OUT
PLAY
MONITOR
OUT
REMOTE 1
A
REMO
RS-422A REMOTE
Socket wrench
SA-K46U
Plate
Hexagon screw
Screw hole
Wire (Red)
REMO
102
– Installing SA-K46U RS-232C interface board –
To prevent electrical shock, remove the AC adaptor before install-
ing SA-K46U.
1.
Remove the RS-422A REMOTE 1 terminal.
1
Remove the two screws Å and pull out the RS-422A REMOTE
1 terminal.
2
Remove the connector cable connected to the connector of
the RS-422A REMOTE board.
❈
Remove the cable carefully not to damage it.
2.
Remove the plate of RS-422A REMOTE 1 terminal.
Plate
• For removing the plate, remove the two hexagonal screws first
Hexagon
with a tool such as a socket wrench.
screw
3.
Remove the SA-K46U plate in the same procedure above.
4.
Fix the plate of RS-422A REMOTE 1 terminal, removed in
above, to SA-K46U.
Hexagonal screws
The screw holes for the hexagonal screws are of the inch system.
Plate
5.
Install the SA-K46U.
1
Connect the connector cable with red wires to the connector of
the SA-K46U board.
Memo
BR-DV6000 connector cable colors
RS-232C: Red
2
Fix SA-K46U to BR-DV6000 with the two screws Å, removed
in
Caution
1
- 1.
RS-422A: Yellow
2