Editing; Editing From A Camcorder; Edit To Or From Another Video Recorder - JVC 0703-AH-PJ-BJ Instruction Manual

Editing

Editing from a camcorder

All necessary cables can be obtained from your dealer.
You can also use another video recorder as the player instead of
a camcorder.
When you select "EDIT" to dub tapes, be sure to select "AUTO"
(or "NORM" when the B.E.S.T. function is set to "OFF") after
you finish dubbing the tapes.
IMPORTANT
To edit, both the player and the recorder must be of the same
colour system. Select the appropriate colour system (
PAL, SECAM and NTSC camcorders can be used as a player
for editing.
a If the camcorder has no S-VIDEO output connector...
VIDEO input
AUDIO
input
Audio/Video Cable
(not provided)
VIDEO OUT
Player
Camcorder
AUDIO OUT
b If the camcorder has an S-VIDEO output connector...
S-VIDEO (S-2)
AUDIO
input
input
Audio Cable (not provided)
S-Video Cable (provided)
S-VIDEO OUT
Player
Camcorder
AUDIO OUT
Recorder
Recorder
You can use a camcorder as the source player and your video
recorder as the recorder.
A
Make connections
aIf the camcorder has no S-VIDEO output connector...
... connect the camcorder's AUDIO/VIDEO OUT connectors to
the recorder's front panel AUDIO/VIDEO input connectors.
bIf the camcorder has an S-VIDEO output connector...
... connect the camcorder's S-VIDEO OUT and AUDIO OUT
connectors to the recorder's front panel S-VIDEO(S-2) and
AUDIO input connectors. The recorder's rear panel S-VIDEO IN
and AUDIO IN input connectors are also available.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your recorder.
When a Master Edit Control-equipped JVC camcorder is used,
16).
the camcorder is capable of controlling the recorder. Refer to
the camcorder's instruction manual for operating procedure.
B
Set recorder's input mode
Press number key "0" and/or PR +/– to select "F-1" for the
AUDIO/VIDEO input connectors, or "S-2" for the AUDIO/S-
VIDEO input connectors, depending on the connectors being
used.
C
Select "EDIT" for picture control set mode
Follow the "Picture Control" section on page 15, then select
"EDIT."
D
Start camcorder
Engage its Play mode.
E
Start recorder
Engage its Record mode.

Edit to or from Another Video Recorder

TV Receiver
VIDEO CHANNEL
RF Cable (provided)
Recorder
AV Cable
(not provided)
Another recorder
Player
— 20 —
Player Your recorder
AV Cable
(not provided)
Another recorder
Recorder
Your recorder
TV Receiver
(MONO)
RF Cable
(provided)
(MONO)
VIDEO
CHANNEL