Adjustment Of Indicator's Brightness; Input/Output Of Rear Ports - JVC RM-LP25U Instructions Manual

Operation
Adjustment of Indicator's
Brightness
The brightness of the indicator light on the control panel can
be adjusted in five levels.
Indicators for which brightness cannot be adjusted:
● [CALL] button
● [PREVIEW] button
● [TALLY] indicator
1
Set the [LOCK] switch to OFF .
OFF
OPERATE
1
PART
1/100
NORMAL 1/120
2
Press and hold the [BARS] button, and operate
the [IRIS/AUTO IRIS LEVEL] lever at the same
time.
● Doing so switches to the brightness adjustment mode,
and the brightness of the indicator light changes.
Self-illuminating
button that
enables
brightness
adjustment
COMPRESS
Note:
● Normal operation is disabled when in the brightness
adjustment mode. However, the [OPERATE] button
remains enabled.
3
Determine the brightness level.
● Releasing the [BARS] button upon selecting a
random brightness level restores the normal mode,
and the corresponding brightness level is stored.
LOCK BARS
PART
OFF FULL
SCENE FILE
SPEED
2 3 4 5
SHUTTER
VARIABLE
1/250 1/500 1/1000 1/2000
OPERATE LOCK BARS
PART
Press and
OFF FULL
SCENE FILE
SPEED
hold
1 2 3 4 5
PART
SHUTTER
1/100
NORMAL 1/120 1/250 1/500 1/1000 1/2000 VARIABLE
GAIN
0dB 3dB
6dB 9dB 12dB 15dB 18dB
LEVEL
-3dB -6dB ALC LOLUX VARIABLE
LEVEL GAMMA LEVEL DETAIL KNEE POINT AUTO
KNEE
BLACK WHITE BALANCE MODE
STRETCH MANUAL PRESET FAW AW A AW B
WHITE PAINT
PAINT AUTO WHITE
R B
BLACK PAINT
PAINT AUTO BLACK
R B
PART
OVER OPEN
PRESET
Lever
IRIS MODE
LEVEL
FULL
AUT
PRE
IR IS
SET
LEV
Operation
AUTO
FULL
TALLY
CALL PREVIEW
UNDER
CLOSE
MASTER
BLACK

Input/Output of Rear Ports

The tally circuit comes with two input systems, namely
contact input and open collector input.
This is set to contact input in the factory settings. You can
change this to open collector input via settings of the DIP
switch at the side of the main unit.
Remove the cover at the side of this product, and set the tally
circuit supply system using DIP switch no. 6. (A 24 page)