1-2. Checking the operation of the white LED
Confirm that the presence sensor is linked with the white LED.
a camera with software version 1.11.0 or later, skip "2." in the following procedure.
1. Using a handkerchief, etc., so the lens is not touched with hands directly, cover
the lens section of the camera
room can be darkened, darken the room without performing procedure 1.)
Presence sensor
2. Cover the presence sensor section of the camera.
3.
After approximately 5 seconds,
sensor and wave your hand in front of the presence sensor and then
confirm that the white LED lights up
the white LED directly.
Wave hand
completely so the light will not get in. (If the
Lens
remove the hand covering the presence
Cover the lens section of the camera
taking care not to look at
When using
Cover the presence
sensor section of the
camera
Do not look directly
9