Connections - JVC HR-VCD1 Instruction Manual

Connections

Make sure that the power to the Player and TV is off before
making the following connections.
OUT1 OUT2
WIRELESS MIC ANT.
AUDIO R
NT8C3.58
AUDIO L
NTSC
ON PAL TV
FREQ
VIDEO
ADJUST
How to connection
1 Connect the TV's VIDEO input and AUDIO input termi-
nals to the Player's VIDEO output and AUDIO output
terminals.
2 Connect the power cord to your household AC outlet.
Notes:
Connection not available with television sets without audio/
video input terminals.
If you put a TV set directly on this Player or install it too close
to a TV set, noise may occur. If this noise occurs, separate
the Player and the TV set.
Video out select (VCD)
Set the VIDEO OUT SELECT switch on the front panel to
NTSC or PAL mode according to your television system.
NTSC ........ for NTSC exclusive TV
PAL .......... for PAL exclusive TV
Note:
If the wrong video system mode for the Video CD is se-
lected, it will not playback with the correct screen size.
NTSC4.43
Colour system output mode selec-
tion (VCP)
To watch an NTSC tape, it will be necessary to select one of the
following output modes.
Selecting the NTSC PLAYBACK ON PAL TV mode
Select this mode to watch NTSC tapes on a PAL system TV.
NTSC
PLAYBACK
ON PAL TV
Selecting the NTSC 3.58 mode
Select this mode to watch NTSC tapes on a NTSC system TV.
NTSC
PLAYBACK
ON PAL TV
Selecting the NTSC 4.43 mode
Select this mode to watch NTSC tapes on a multi-system TV
(that has an NTSC 4.43 setting).
Select NTSC 4.43 to record NTSC 4.43 signal.
NTSC
PLAYBACK
ON PAL TV
Note:
Adjust the System Output switch to the appropriate position
in order to record NTSC signals.
Select the NTSC PLAYBACK ON PAL TV or NTSC 3.58 to
record NTSC 3.58 signals.
Select NTSC 4.43 to record NTSC 4.43 signals.
NTSC3.58
NTSC4.43
NTSC3.58
NTSC4.43
NTSC3.58
NTSC4.43
9