10.2.2. Machinery Inspection
Make an overall inspection of the machinery spaces. Ensure that they are free
•
of loose material that might interfere with machinery operation, and then check
the following items:
Engine oil, transmission fluid, and coolant levels satisfactory.
•
All electrical switches OFF.
•
Batteries fully charged, tied down, connected; electrolyte at proper level.
•
Installation of all equipment completed.
•
All fuel and propane valves CLOSED.
•
Adequate amount of fuel in tank.
•
Check to be sure that the shaft coupler is attached to the transmission.
•
Check filters: Bilge, shower-sump, fresh water, and engine raw water.
•
10.2.3. Before Stepping Mast
WARNING! MOVE YOUR BOAT TO A POSITION THAT IS CLEAR
OF OVERHEAD WIRES OR OBSTRUCTIONS.
MAY RESULT FROM CONTACT WITH ANY OVERHEAD WIRES!!
* Check the following items:
• • • •
Shrouds, stays, spreaders, installed and properly secured to mast.
•
Check standing rigging for kinks or defects.
•
Masthead lights, spreader lights, and mast-mounted instrument units
•
operational.
VHF antenna installed. (If applicable)
•
All chafe points on mast properly taped.
•
If the mast is keel stepped: check that the mast has been choked correctly and
•
that the mast boot has been installed and sealed.
10.2.4. Equipment On Board
Check the following items:
* Winch handles, emergency tiller, and bilge pump handles.
•
** Anchor and ground tackle.
•
** Dock lines and fenders.
•
** Safety equipment:
•
1. Life preservers
2. Throwable horseshoe or ring buoy
06/12/08
9:05 AM
Rev. 05
21
ELECTROCUTION