Checking The Power Cord; Warnings And Cautions - digital rapids TouchStream User Manual

Digital Rapids TouchStream

Checking the Power Cord

WARNING
Do not attempt to modify or use the supplied AC power cord if it is not the exact
type required.
The power supply cord is the main disconnect to AC power. The socket outlet
must be installed near the equipment and be readily accessible.
If the power cord supplied with the system is not compatible with the AC wall
outlet in your region, get one that meets the following criteria:
•
The cord must be rated for the available AC voltage and have a current
rating that is at least 125% of the current rating of the server.
•
The plug on the power cord that plugs into the wall outlet must be a
grounding-type male plug designed for use in your region. It must have
certification marks showing certification by an agency acceptable in your
region.
•
The connector that plugs into the AC receptacle on the power supply
must be an IEC 320, sheet C13, type female connector.
•
In Europe, the cord must be less than 4.5 meters (14.76 feet) long, and it
must be flexible <HAR> (harmonized) or VDE certified cordage to comply
with the chassis' safety certifications.
•
The user must comply with local electrical code requirements.

Warnings and Cautions

These warnings and cautions apply whenever you remove the chassis cover to
access components inside the chassis. Only a technically qualified person should
integrate and configure the unit.
WARNING / BEFORE YOU REMOVE THE ACCESS COVER
Before removing the access cover for any reason, observe these safety
guidelines:
1. Turn off all peripheral devices connected to the unit.
2. Turn off the unit by pressing the power button on the front of the chassis.
Then unplug the AC power cord from the chassis or wall outlet.
3. Label and disconnect all peripheral cables and all telecommunication
lines connected to I/O connectors or ports on the back of the chassis.
Page 2