Pause/Resume - digital rapids TouchStream User Manual

•
Duration: Specify how long you want to run the encode in
hours:minute:seconds using the numeric keypad on the right hand side of
the screen.
•
End Time: Specify a time to end the encode in hours:minute:seconds
using the numeric keypad on the right hand side of the screen. This time
will be based on the system time. The current time is displayed at the
bottom of the screen. All times use a 24 hour clock.
Scheduled Trigger
When you select Scheduled Trigger TouchStream can monitor the system clock
to set a Start Time and a Stop Time for the encode.
Note that once the Scheduled Trigger has been armed you can override both the
start and stop manually if desired by pressing the Start or Stop button on the
main screen.
Arm, Disarm, Cancel
When you press the Arm button your selected trigger type will be active, and you
will be returned to the main screen. If you press the Disarm button any previously
selected trigger will be disabled. If you want to exit the trigger screen without
changing any settings, press the Cancel button.

Pause/Resume

While the TouchStream unit is encoding the Pause button will be available.
If you press the Pause button it will change to a Resume button.
Digital Rapids TouchStream
Page 11