Warning: English (Usa) - digital rapids TouchStream User Manual

Digital Rapids TouchStream

WARNING: English (USA)

The power supply in this product contains no user-serviceable parts. Refer
servicing only to qualified personnel.
Do not attempt to modify or use the supplied AC power cord if it is not the exact
type required.
The power button on the system does not turn off system AC power. To remove
AC power from the system, you must unplug the AC power cord from the wall
outlet or power supply.
The power cord is considered the disconnection device to the mains (AC) power.
The socket outlet that the system plugs into shall be installed near the equipment
and shall be easily accessible.
SAFETY STEPS: Whenever you remove the chassis cover to access the inside
of the system, follow these six steps:
1. Turn off all peripheral devices connected to the system.
2. Turn off the system by pressing the power button.
3. Unplug all AC power cords from the system or from wall outlets.
4. Label and disconnect all cables connected to I/O connectors or ports on the
back of the system.
5. Provide some electrostatic discharge (ESD) protection by wearing an
antistatic wrist strap attached to chassis ground of the system—any
unpainted metal surface—when handling components.
6. Do not operate the system with the chassis cover removed.
After you have completed the six previous SAFETY steps, you can remove the
system cover.
For proper cooling and airflow, always reinstall the chassis covers before turning
on the system. Operating the system without the cover in place can damage
system parts. To install the cover:
1. Check first to make sure you have not left loose tools or parts inside the
system.
2. Check that cables, add-in boards, and other components are properly
installed.
Page 38