Advertisement
PRODUCT REFERENCE GUIDE
Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all
the warnings and safety guidelines before use. This product is for use with the VALCO Latitude stroller in North
American only. This product is not intended for use in Australia.
Important: Please read the following instructions carefully before assembling this product. Retain this
guide in a safe place for future reference.
FURTHER INFORMATION
North America only
www.valcobaby.com
1800 610 7850
Latitude Car Seat
Adapter
Compatible with most Peg Perego Car Seats
Due to our policy of continuous
product development, this
product is constantly evolving. It
is possible that some features or
procedures outlined here have
changed since this document
was written. If you are unsure
of any procedure shown here,
please contact us via the web at
info@valcobaby.com to obtain
the most up to date information
before use. Include the batch
number, which can be found on a
sticker on the frame.
All pictures and diagrams herein
are provided for illustration
purposes only. Actual product,
colour or fabric may vary. VALCO
reserves the right to modify or
alter any specification or colour
without notice or obligation to
modify any product previously
purchased
© Copyright VE 2008
Advertisement
Table of Contents
Related Manuals for Valco baby Latitude
Summary of Contents for Valco baby Latitude
- Page 1 Familiarise yourself with the construction and safety features; be sure that you understand all the warnings and safety guidelines before use. This product is for use with the VALCO Latitude stroller in North American only. This product is not intended for use in Australia.
- Page 2 INsTALLINg yOUR PEg PEREgO CAR sEAT ADAPTOR FIgURE A 1. Begin preparing the Latitude stroller for the Car seat Adaptor by removing the canopy (hood), from the stroller, and reclining the seat to its fully reclined position, (detailed Seat Reclined instructions in the Latitude stroller Instruction Manual).
- Page 3 FIgURE E 6. Align an adapter connector piece with the corresponding raised piece on the stroller (where the hood connects) (4). 7. slide the connector piece onto the stroller. Be sure that the adapter is locked into place (5). 8. Repeat on the other side. FIgURE F Press 9.
- Page 4 FIgURE I 16. Once your car seat is inserted, locate the remaining set of straps. 17. Take the Male/Female strap and slip the strap through the car seat belt hook on the side of the car seat. 18. Repeat with the other strap. 19.
Need help?
Do you have a question about the Latitude and is the answer not in the manual?
Questions and answers