Valco baby LATITUDE Product Reference Manual

Table of Contents

Download this manual

PRODUCT REFERENCE GUIDE

Thank you for purchasing a quality Valco Baby product. Please read and follow the instructions outlined in this

guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all

the warnings and safety guidelines before use.

Retain this guide in a safe place for future reference.

LATITUDE

STROLLER

Due to our policy of continuous product

development, this product is constantly

evolving. It is possible that some features or

procedures outlined here have changed since

this document was written.

If you are unsure of any procedure shown

here, please contact us via the web at

info@valco.com.au to obtain the most

up to date information before use. Include

the batch number, which can be found on a

sticker on the frame.

All pictures and diagrams herein are provided

for illustration purposes only. Actual product,

colour or fabric may vary. Valco Baby reserves

the right to modify or alter any specification

or colour without notice or obligation to

modify any product previously purchased

FURTHER INFORMATION

In Australia/New Zealand

www.valco.com.au

In North America only

www.valcobaby.com

1800 610 7850

vs201010

Table of Contents

Need help?

Do you have a question about the LATITUDE and is the answer not in the manual?

Page 1 STROLLER PRODUCT REFERENCE GUIDE Thank you for purchasing a quality Valco Baby product. Please read and follow the instructions outlined in this guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all the warnings and safety guidelines before use.
Page 2 assembly FIGURE A 1. Lift the handle upward toward you. The frame will begin to open. 2. Continue opening the frame until you hear it “click” into the fully locked position. IMPORTANT: CHECK THAT ALL SEAT STUDS ARE FULLY click ENGAGED BEFORE USE Install the rear axle/brake bar FIGURE B...
Page 3 IMPORTANT: ALWAYS TEST THAT THE bRAkES ARE fULLY ENgAgED bY PUSHINg THE STROLLER fORWARD AND bACkWARD. to FolD yoUr latItUDe stroller FIGURE H 19. IMPORTANT: bEfORE fOLDINg, THE SEAT MUST bE IN A RECLINE POSITION Of AT LEAST 30%. If THE SEAT IS NOT RECLINED, THE HOOD MAY POP Off THE fRAME DURINg fOLDINg.
Page 4 MAy Be in the iMMeDiAte ViCinity oF your stroller. • it MAy Be unsAFe to use Any ACCessories other thAn VAlCo BABy ApproVeD ones. • this proDuCt is intenDeD For DoMestiC use only. it is not intenDeD For CoMMerCiAl use.