Raleigh Audio RAKK dac Mark III Extreme Preamplifier Assembly Manual page 29

Wire the Select Switch
2. Connect the green wire from the ground buss to the "com" pad on the Analog Select board.
————————————————————————————
Wire the Power Switch
The power switch has four terminals. These are two pair that will be used in parallel, so each
wire will be connected to two terminals. One wire will be connected to the two terminals closest
to the end of the switch and the other wire will be connected to the two terminals closest to the
center of the switch.
3. Locate the #20 black twisted pair that is an extension from the white/black power cable.
Connect this black twisted pair to the four terminals on the power-on switch.
————————————————————————————
Wire the Power-on LED
4. Locate the #22 black twisted pair from the pins B5 and B2 on the power transformer.
5. Solder the wires to the LED leads about ⅛" from the body of the LED.
————————————————————————————
28