Raleigh Audio RAKK dac Mark III Extreme Preamplifier Assembly Manual page 28

Wire the Volume Control
1. Connect the twisted pairs from the "volume control" pads on the Active Output board to the
volume control as follows:
• Connect the blue wire to the tab extending from the switch wafer closest to the front
panel.
• Connect the associated black wire to the "com" pad on the board closest to the front
panel.
• Connect the orange wire to the tab extending from the switch wafer closest to the back of
the switch.
• Connect the associated black wire to the "com" pad on the board closest to the back of
the switch.
————————————————————————————
27