Thelin Pellet Heater Owner's Manual Installation And Operating Instructions

Advertisement

Quick Links

ECHO PELLET E.I.
Pellet Heater Owner's Manual

Installation and Operating Instructions

Please read this entire manual before installation and use of the pellet fuel-burning room heater. Failure to follow these instructions
 HEATER MUST BE PROPERLY INSTALLED AND MAINTAINED OR A HOUSE FIRE MAY
RESULT.
 FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
 CONTACT LOCAL BUILDING OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION
INSPECTION AND PERMIT REQUIREMENTS.
 FAILURE TO COMPLY WITH OWNER'S MANUAL INSTRUCTIONS WILL VOID
WARRANTY AND COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN
DEATH.
PLEASE LEAVE THIS MANUAL WITH THE OWNER!!
TH-REF-SLS-230 Rev. A
could result in property damage, bodily injury or even death.
SAFETY NOTICE
Warnock Hersey Test Labs, Middleton, WI
II
Made in the USA by:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pellet Heater and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Thelin Pellet Heater

  • Page 1: Installation And Operating Instructions

    ECHO PELLET E.I. Pellet Heater Owner's Manual Installation and Operating Instructions Made in the USA by: Please read this entire manual before installation and use of the pellet fuel-burning room heater. Failure to follow these instructions could result in property damage, bodily injury or even death.
  • Page 2: Table Of Contents

    ECHO PELLET E.I. II PELLET HEATER INDEX OF CONTENTS Appendix A, 25 Installation, 7 Appendix B, 26 battery, 16 Appendix C, 27 clean out tee, 7 Appendix D, 28 distance to openings, 7 Battery floor protection, 7 installation, 16 pipe configuration, 8...
  • Page 3 ECHO PELLET E.I. II PELLET HEATER FIGURES Figure 1 - Overall Dimensions ..........................6 Figure 2 ................................... 6 Figure 3 ................................... 7 Figure 4 ................................... 8 Figure 5 ................................... 9 Figure 6 ................................. 10 Figure 7 ................................. 11 Figure 8 ................................. 13 Figure 9 .................................
  • Page 4: Laboratory Listing Label

    ECHO PELLET E.I. II PELLET HEATER LABORATORY LISTING LABEL...
  • Page 5: Introduction And Safety Information

    ECHO PELLET E.I. II PELLET HEATER GENERAL INFORMATION Installation and repair should be done by a qualified NOTE: During the first few burns the high- service person. The heater should be inspected temperature paint and sealant used in manufacture before use and once a year by a qualified service will emit some odor and smoke.
  • Page 6: Clearances

    ECHO PELLET E.I. II PELLET HEATER CLEARANCES CHECK WITH LOCAL BUILDING OFFICIALS FOR SPECIFIC CODE REQUIREMENTS. A LISTED, TYPE "L" PELLET VENT PIPE IS MANDATORY ON ALL INSTALLATIONS. Clearance to Combustibles Unit to Sidewall ........5" (125 mm) Unit to Backwall ........3" ( 75 mm) Unit to Diagonal Wall ......3.5"...
  • Page 7: Clean Out Tee

    ECHO PELLET E.I. II PELLET HEATER 5. Keep front door of appliance thirty-six (36) INSTALLATION inches from combustibles (drapery, furniture). 1. When deciding on the location of your heater 6. When installing the exhaust vent into an and vent pipe, minimize the alteration and...
  • Page 8: Pipe Configuration

    ECHO PELLET E.I. II PELLET HEATER FIGURE 4...
  • Page 9: Figure 5

    ECHO PELLET E.I. II PELLET HEATER FIGURE 5...
  • Page 10: Figure 6

    ECHO PELLET E.I. II PELLET HEATER FIGURE 6...
  • Page 11: Pipe Connections

    ECHO PELLET E.I. II PELLET HEATER 9. The pellet heater must be operated with a power Horizontal runs must be limited to 2 feet. On source and will not operate using natural draft. vertical runs on an exterior wall, a wall If there is a power failure the heater will shut band is required every 4 feet.
  • Page 12: Wall & Remote Thermostat

    ECHO PELLET E.I. II PELLET HEATER temperature cycling on/off WALL & REMOTE THERMOSTAT constantly. INSTALLATION FOR ECHO E.I. 6. Be aware that the life of the igniter is affected by the ash build up in the fire pot and the The wall thermostat is designed to automatically number of times the stove is cycling on/off.
  • Page 13: Figure 8

    ECHO PELLET E.I. II PELLET HEATER FIGURE 8...
  • Page 14: Filling

    ECHO PELLET E.I. II PELLET HEATER SAFETY SWITCH TURNS OFF PELLET FEED MOTOR WHEN PELLET HOPPER DOOR IS OPEN FIGURE 9 FIGURE 10 Use good-quality pellets that give a vibrant, yellow START-UP AND OPERATION flame with little or no soot. Poor quality pellets will burn rich with black sooty smoke and ash will A.
  • Page 15: Control Functions

    ECHO PELLET E.I. II PELLET HEATER B. Lighting Instructions The Echo E.I. has automatic ignition. Simply plug in the stove, fill with pellets and push the low, medium or high button on the control panel. When the button is pushed to low, medium or high the igniter will come on and in one minute the feed motor will activate and begin feeding pellets.
  • Page 16: Installation

    ECHO PELLET E.I. II PELLET HEATER 4. In the "High" position, the Echo will feed present. Maintenance is required and thorough approximately 5 pounds of pellets per hour. The cleaning and pipe check must be performed if these flame will fluctuate between 3 inches and a full conditions persist.
  • Page 17: Fly Ash Removal

    ECHO PELLET E.I. II PELLET HEATER on the stove. The red must be plugged in MAINTENANCE PROCEDURES first before the black (see FIGURE 8). CAUTION: Moving parts may cause injury. DO b. Connect the black battery cable to the (-) NOT operate with rear cover removed.
  • Page 18: Heat Exchanger

    ECHO PELLET E.I. II PELLET HEATER around and below the pot should be checked every five or six days depending on how many hours a day the heater is used and the quality of the pellets being burned. Remove the fire pot holder for thorough cleaning (see FIGURE 12).
  • Page 19: Fan Guard

    ECHO PELLET E.I. II PELLET HEATER 12). (See FIGURE 16 for routine stove clean- causing the jam. ENSURE THE POWER IS out and maintenance.) OFF. Remove any foreign material or object and restart the heater. CAUTION: Keep fingers and 3. Cleaning the Fan Guard: The plastic fan guard...
  • Page 20 ECHO PELLET E.I. II PELLET HEATER expected, purchasing a battery back-up system 9. Problem: Stove shuts off when running on low. is recommended. If the vent pipe is installed Solution: Feed is too low. Adjust feed trim according to these instructions, the smoke will button (turn clockwise) until feed can maintain siphon out of the pipe in most instances.
  • Page 21: Replacement Parts List

    ECHO PELLET E.I. II PELLET HEATER FIGURE 13 – REPLACEMENT PARTS LIST...
  • Page 22: Circuit Board Diagram

    ECHO PELLET E.I. II PELLET HEATER FIGURE 14 - CIRCUIT BOARD DIAGRAM Type 1 – Thermo On/Off Type 2 – Thermo Hi/Lo...
  • Page 23: Wiring Diagram

    ECHO PELLET E.I. II PELLET HEATER FIGURE 15 - ELECTRICAL SCHEMATIC/WIRING DIAGRAM...
  • Page 24: Routine Maintenance

    ECHO PELLET E.I. II PELLET HEATER FIGURE 16 – ROUTINE STOVE CLEAN OUT AND MAINTENANCE The following is a step-by-step procedure to clean out and maintain your pellet stove. Stove must be shut off and completely cold before performing this maintenance.
  • Page 25: Wind Warning

    (see FIGURE This Thelin Pellet Stove is equipped with a blocked flue/high temp safety sensor that will shut the stove off if there is a down draft, blocked flue, or high temperature condition.
  • Page 26: Firepot Assembly

    ECHO PELLET E.I. II PELLET HEATER APPENDIX B – E.I. FIREPOT ASSEMBLY...
  • Page 27: Fine Tuning

    ECHO PELLET E.I. II PELLET HEATER APPENDIX C – FINE TUNING run of pipe (over 10’) will warm the pipe; Because of the variability of pellets (i.e., length thickness, density, quality of sawdust), fine consequently, the draw can be intense...
  • Page 28: Igniter Removal

    ECHO PELLET E.I. II PELLET HEATER APPENDIX D – IGNITER REMOVAL...
  • Page 29: Warranty Information

    Thelin Hearth Products, Warranty Division, 12400 Loma Rica Drive, Grass Valley, CA 95945. Returned part or product will be repaired or replaced at Thelin Hearth Products option and will be returned to you freight prepaid as soon as practical, but not later than 30 days after receipt.
  • Page 30 ECHO PELLET E.I. II PELLET HEATER...

This manual is also suitable for:

Echo pellet e.i. ii

Table of Contents