Adjusting The Surround Modes - JVC RX-888VBK Instructions Manual

3. Adjust the effect level.
1) Press BALANCE/SURROUND
ADJUST repeatedly until "DSP
EFFECT" appears on the display.
The display changes to show the current
setting.
2) Turn MULTI JOG to select the effect
level.
• As you turn it, the effect level changes
as follows:
DSP EFFECT 1
DSP EFFECT 5
As the number increases, the selected DAP mode becomes
stronger.
From the remote control:
1. Press SURROUND MODE
repeatedly until the DAP mode —
LIVE CLUB, DANCE CLUB,
HALL, or PAVILION — appears
on the display.
The DSP and the selected DAP mode indicators also light up on
the display.
2. Press SOUND.
The 10 keys are activated for sound adjustments.
3. Adjust the speaker output levels.
• To adjust the left rear speaker level, press
REAR•L –/+ (from –10 dB to +10 dB).
• To adjust the right rear speaker level, press
REAR•R –/+ (from –10 dB to +10 dB).
4. Press EFFECT to select an effect
level you want.
• Each time you press the button, the effect
level changes as follows:
DSP EFFECT 1
DSP EFFECT 5
As the number increases, the selected DAP mode becomes
stronger.
BALANCE/SURROUND
DSP EFFECT 2 DSP EFFECT 3
DSP EFFECT 4
SURROUND
REAR•L
5
ENTER ENTER
8
EFFECT
7
DSP EFFECT 2 DSP EFFECT 3
DSP EFFECT 4

Adjusting the Surround Modes

ADJUST
Once you have adjusted the Surround modes, the adjustment is
memorized for each Surround mode.
Dolby and DTS Surround adjustments
MULTI JOG
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 14).
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• You cannot adjust the rear speaker output levels when you have set
"REAR SPK" to "NONE." See page 14.
• You cannot adjust the center speaker output level and center tone
when you have set "CENTER SPK" to "NONE." See page 14.
From the remote control:
1. Press SURROUND MODE
repeatedly until the mode — PRO
MODE
LOGIC, DOLBY DIGITAL, or
DTS SURROUND — appears on
the display.
• When "PRO LOGIC" is selected, the PRO LOGIC indicator
lights up on the display.
Note:
SOUND
You can also press SURROUND ON/OFF to activate an
appropriate Surround mode — PRO LOGIC, DOLBY DIGITAL, or
DTS SURROUND. Each time you press the button, the Surround
mode turns on and off alternately.
6
2. Press SOUND.
The 10 keys are activated for sound adjustments.
REAR•R
3. Press TEST to check the speaker
9
output balance.
"TEST TONE L" starts flashing on the
display, and a test tone comes out of the
speakers in the following order:
/P
TEST TONE L
(Left front speaker)
TEST TONE C
(Center speaker)
TEST TONE LS
(Left rear speaker)
SURROUND
MODE
SOUND
TEST
4
TEST TONE R
(Right front speaker)
TEST TONE RS
(Right rear speaker)